Steam injection heating and drying acceleration
Cut heating and drying time with direct pure steam injection into the water circuit. Faster heat-up and accelerated drying reduce cycle duration, increase throughput and support GMP-compliant operation where pure steam is available.
Where cycle time is lost
In many washer cycles, total duration is largely driven by heating and drying phases. Conventional systems rely on electrical heaters or steam coils in the sump, which require time to transfer energy into the water before the required temperature is reached. The same applies to drying, where parts must first accumulate sufficient thermal energy before moisture can evaporate efficiently.
Long heat-up and drying times directly limit throughput, especially in high-demand production environments.
One principle, two applications
SteelcoBelimed uses injection of Pure Steam to reduce the heating and drying step, with two approaches that can be used independently or combined within the same recipe, depending on load requirements.
Faster cycles with GMP compatibility
Because pure steam is used, the solution remains fully compatible with pharmaceutical GMP requirements. Steam acts as a rapid heat transfer medium within the water circuit, without transforming the washer into a pressure vessel.
Shorter heating and drying phases translate into faster overall cycles and higher throughput. Reduced step duration can also contribute to lower water consumption. Recipes can be adapted to the specific load, avoiding unnecessarily long heat-up or drying times.
This is a simple enhancement with significant impact, particularly suited to facilities where pure steam is already available in the washer area.
